ISOLED phase-on/phase-off (40-230V)/push input signal to PWM dimmer
Product-No. 114431     

ISOLED phase-on/phase-off (40-230V)/push input signal to PWM dimmer

Phase on/phase off (40-230V)/push input signal to PWM dimmer, 1 channel, 12-48V DC 15A

Delivery time: 3 - 5 Days
Country:
Material

Plastic

Manufacturer

ISOLED

Width

16 g

Height

27 mm

Voltage

48 V

Watt

720 W

Length

175 mm

IP protection class

IP 20

Housing color

White

UVP 46,64 $
-39%
26,58 $
plus 19% tax, plus shipping
(Gross price 31,63 $)
Compare
Add to watchlist
Ask question
Downloads & datasheets

Product description ISOLED phase-on/phase-off (40-230V)/push input signal to PWM dimmer

ISOLED phase on/phase off (40-230V)/push input signal to PWM dimmer.

Features:

Triac dimming, input 40-220V AC dimming signal. One channel PDM constant voltage output, output current max 15A PDM digital dimmer, logarithmic dimming curve. Over voltage protection, short circuit protection, overheating protection. Optional pushbutton input.

Control by incoming 40-230V AC sine wave modulated control voltage via phase on or phase off dimmer, optional additional closing push button can be connected, PWM output frequency 500Hz.

Triac Dimming Input:

40-220V AC dimming signal can reach 0-100% brightness, the brightness is proportional to the dimming
Signal. If the brightness does not reach 0% or 100%, please check if the input voltage can reach the lowest or highest voltage respectively.

When connected to a triac dimmer, such as Lutrom, Clipsal, Dynalite dimmer. Triac dimmers from different suppliers may have different minimum dimming levels, which the driver cannot convert. To dim to 1% please make sure that the dimmer supports 1% as minimum dimming level.

The product adapts the analog dimming signal (phase angle/intercept) and adjusts the brightness accordingly, adjust the brightness between different triac dimmers using a potentiometer (potiometer).

The triac dimmer or the push switch can be connected at the same time, this makes the product more user-friendly and gives more freedom for extraordinary demands.

When the product is used with the push dim interface before the triac interface, the triac dimming signal should be set to more than 10% to restore the triac control.

Push-Dim AC Function:

Short press:
Turns off the light.

Long press (1-6 sec):
Press and hold for stepless dimming, with each further press and hold the light will be dimmed brighter or dimmer.

Dim memory:
The last dimming level selected is retained after power off, even after a power failure.

Synchronization:
If more than one receiver is connected to the same push button, press for more than 10 seconds, then the system is synchronized and all lights in the groups dim to 100%. This means that in larger installations no additional cable is needed for synchronization. We recommend not to connect more than 25 receivers to one pressure switch. The maximum connection length of the cable between pressure switch and receiver should not exceed 20m.

Top brands